Inspiron 3505 Service Manual

PDF

Installing the display assembly

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following images indicate the location of the display assembly and provides a visual representation of the installation procedure.

Image:Installing the display assembly

Image:Installing the display assembly

Steps

  1. Place the display assembly on the palm-rest and keyboard assembly.
  2. Align the screw holes on the display hinges with the screw holes on the palm-rest and keyboard assembly.
  3. Replace the 6 screws (M2.5x6) that secure the display hinges to the palm-rest and keyboard assembly.
  4. Route the display cable through the routing guides on the palm-rest and keyboard assembly.
  5. Connect the display cable to the connector on the system board.

Next steps

  1. Install the wireless card.
  2. Install the base cover.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\