
Inspiron 3505 Service Manual
Installing the heat sink
Prerequisites
About this task
NOTE:If either the system board or the heat sink is replaced, use the thermal grease provided in the kit to ensure that thermal conductivity is achieved.
The following image indicate the location of the heat sink and provides a visual representation of the installation procedure.

Steps
- Place the heat sink on the system board.
- In sequential order (1>2>3>4) tighten the four screws (M2x5.2) that secure the heat sink to the system board.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\