Inspiron 3505 Service Manual

PDF

Removing the power-button with optional fingerprint reader

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the I/O board.

About this task

The following images indicate the location of the power-button with optional fingerprint reader and provides a visual representation of the removal procedure.

Image:Removing the power-button with optional fingerprint reader

Steps

  1. Remove the two screws (M2x3) that secure the power-button with optional fingerprint reader to the palm-rest and keyboard assembly.
  2. Open the latch and disconnect the power-button cable from the fingerprint-reader board, if applicable.
    NOTE:This step is only applicable if your computer was shipped with the optional fingerprint reader.
  3. Peel the Mylar that secures and grounds the power-button cable to the palm-rest and keyboard assembly, if applicable.
    NOTE:This step is only applicable if your computer was shipped with the optional fingerprint reader.
  4. Lift the power-button, along with its cable, off the palm-rest and keyboard assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\