Me and My Dell For Inspiron, G-Series, XPS, and Alienware computers

PDF

Beep codes

Your computer may emit a series of beeps during start-up if there are errors or problems. This series of beeps, called a beep code, identifies a problem. If this occurs, note the beep code and contact Dell for assistance.
NOTE Some of the beep codes mentioned in the table below may not apply to your computer.
Table 1. Beep codes and possible problemsThis table provides a list of the beep codes and possible problems.
Beep codesPossible problems
OnePossible system board failure—BIOS ROM checksum failure.
TwoNo RAM detected
NOTE If you installed or replaced the memory module, ensure that the memory module is seated properly.
ThreePossible system board failure—Chipset error
FourRAM read/write failure
FiveReal‑time Clock failure
SixVideo card or video controller failure
SevenProcessor failure
NOTE This beep code is supported for computers with Intel processor only.
EightDisplay failure

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\