Inspiron 16 5620 - for computers with DDR4 memory Service Manual

PDF

Deleting or changing an existing system setup password

Prerequisites

Ensure that the Password Status is Unlocked (in the System Setup) before attempting to delete or change the existing System and/or Setup password. You cannot delete or change an existing System or Setup password, if the Password Status is Locked.

About this task

To enter the System Setup, press F12 immediately after a power-on or reboot.

Steps

  1. In the System BIOS or System Setup screen, select System Security and press Enter.
    The System Security screen is displayed.
  2. In the System Security screen, verify that Password Status is Unlocked.
  3. Select System Password, update, or delete the existing system password, and press Enter or Tab.
  4. Select Setup Password, update, or delete the existing setup password, and press Enter or Tab.
    NOTE:If you change the System and/or Setup password, reenter the new password when prompted. If you delete the System and/or Setup password, confirm the deletion when prompted.
  5. Press Esc and a message prompts you to save the changes.
  6. Press Y to save the changes and exit from System Setup.
    The computer restarts.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\