Inspiron 16 5620 - for computers with DDR4 memory Service Manual
Installing the base cover
Prerequisites
About this task
The following image(s) shows the base cover and provides a visual representation of the installation procedure.
Steps
- Ensure that the battery cable has been connected to the system board.
- Place and snap the base cover into place on the palm-rest and keyboard assembly.
- Tighten the two captive screws on the base cover.
- Replace the seven screws (M2x4) that secure the base cover to the palm-rest and keyboard assembly.
Next steps
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\