Inspiron 16 5620 - for computers with DDR4 memory Service Manual

PDF

Installing the fan

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the fan and provides a visual representation of the installation procedure.

Installing the fan

Steps

  1. Align the screw holes of the fan with screws on the palm-rest and keyboard assembly.
  2. Replace the two screws (M2x3) that secure the fan to the palm-rest and keyboard assembly.
  3. Connect the fan cable to the system board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\