Inspiron 16 5620 - for computers with DDR4 memory Service Manual

Installing the heatsink

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

NOTE:If either the system board or the heat sink is replaced, use the thermal grease provided in the kit to ensure that thermal conductivity is achieved.

NOTE:The number of screws on the heat sink varies depending on the graphic card configuration ordered.

The following image(s) indicate the location of the heatsink and provides a visual representation of the installation procedure.

NOTE:This is the heatsink for your computer that supports the discrete Graphics Processing Unit (GPU).

NOTE:This is the heatsink for your computer that supports the integrated Graphics Processing Unit (GPU).

Steps

Align the screw holes on the heat sink to the screw holes on the system board.
In sequential order (1>2>3>4>5>6>7) or (1>2>3>4), tighten the seven or four captive screws, whichever is applicable, that secure the heat sink to the system board.

Next steps

Install the base cover.
Follow the procedure in After working inside your computer.