Inspiron 16 5620 - for computers with DDR4 memory Service Manual

PDF

Installing the palm-rest and keyboard assembly

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the palm-rest and keyboard assembly and provides a visual representation of the installation procedure.

Installing the palm-rest and keyboard assembly

Steps

Place the palm-rest and keyboard assembly on a flat and clean surface and perform the post-requisites to install the palm-rest and keyboard assembly.
NOTE:The palm-rest and keyboard assembly includes the following components:
  • Palm rest
  • Keyboard
  • Wireless antenna (2)

Next steps

  1. Install the touchpad.
  2. Install the speakers.
  3. Install the system board.
  4. Install the power-adapter port.
  5. Install the power-button board.
  6. Install the power button.
  7. Install the I/O board.
  8. Install the coin-cell battery.
  9. Install the fan.
  10. Install the display assembly.
  11. Install the battery.
  12. Install the wireless card.
  13. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive, whichever is applicable.
  14. Install the memory module.
  15. Install the base cover.
  16. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\