Inspiron 16 5620 - for computers with DDR4 memory Service Manual

PDF

Installing the power button with optional fingerprint reader

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the power button and provides a visual representation of the installation procedure.

Installing the power button

Steps

  1. Align the screw hole on the power button with the screw hole on the palm-rest and keyboard assembly.
  2. Place the power button on the palm-rest and keyboard assembly.
  3. Replace the screw (M2x3) that secures the power button to the palm-rest and keyboard assembly.
  4. Replace the adhesive tape that secures the power-button cable to the palm-rest and keyboard assembly.

Next steps

  1. Install the power-button board.
  2. Install the base cover.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\