Inspiron 16 5620 - for computers with DDR4 memory Service Manual

PDF

Installing the speakers

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

NOTE:If either the system board or the heat sink is replaced, use the thermal grease provided in the kit to ensure that thermal conductivity is achieved.

The following image(s) indicate the location of the speakers and provides a visual representation of the installation procedure.

Installing the speakers

Steps

  1. Using the alignment posts, place the left and right speakers on the palm-rest and keyboard assembly.
  2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
  3. Adhere the tapes that secure the speaker cable to the palm-rest and keyboard assembly.
  4. Connect the touchpad cable and close the latch of the touchpad connector on the system board.
  5. Connect the keyboard cable and close the latch of the keyboard connector on the system board.
  6. Connect the keyboard backlit cable and close the latch of the keyboard backlit connector on the system board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\