Inspiron 16 5620 - for computers with DDR4 memory Service Manual
Removing the base cover
Prerequisites
- Follow the procedure in
Before working inside your computer.
NOTE:Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your computer.
About this task
NOTE:Before removing the base cover, ensure that there is no SD card installed in the SD card slot on your computer.
The following image(s) shows the base cover and provides a visual representation of the removal procedure.
Steps
- Remove the seven screws (M2x4) that secure the base cover to the palm-rest and keyboard assembly.
- Loosen the two captive screws.
- Using a plastic scribe, pry the base cover from the bottom left and continue to work on the sides to open the base cover.
- Lift and slide the base cover off the palm-rest and keyboard assembly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\