Inspiron 16 5620 - for computers with DDR4 memory Service Manual
Removing the heatsink
Prerequisites
- Follow the procedure in
Before working inside your computer.
NOTE:Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your computer.
- Remove the base cover.
About this task
NOTE:The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you touch it.
NOTE:For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The oils in your skin can reduce the heat transfer capability of the thermal grease.
NOTE:The number of screws on the heat sink varies depending on the graphic card configuration ordered.
The following image(s) indicate the location of the heatsink and provides a visual representation of the removal procedure.
NOTE:This is the heatsink for your computer that supports the
discrete Graphics Processing Unit (GPU).
NOTE:This is the heatsink for your computer that supports the
integrated Graphics Processing Unit (GPU).
Steps
- In reverse sequential order (7>6>5>4>3>2>1), or (4>3>2>1), whichever is applicable, loosen the seven or four captive screws, whichever is applicable, that secure the heat sink to the system board.
- Lift the heat sink from the system board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\