Inspiron 16 5620 - for computers with DDR4 memory Service Manual
Removing the M.2 2280 solid-state drive
Prerequisites
- Follow the procedure in
Before working inside your computer.
NOTE:Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your computer.
- Remove the base cover.
About this task
NOTE:This procedure applies only to computers shipped with an M.2 2280 solid-state drive installed.
NOTE:The M.2 solid-state drive installed on your computer depends on the configuration ordered. The M.2 slot supports one of the following solid-state drives:
- M.2 2230 solid-state drive
A mounting bracket for the M.2 2230 solid-state drive is required. The mounting bracket is provided if the M.2 2230 solid-state drive is shipped with the computer.
If you are replacing the M.2 2230 solid-state drive with a new M.2 2230 solid-state drive, use the existing mounting bracket to install the latter.
- M.2 2280 solid-state drive
If you are replacing the M.2 2280 solid-state drive (shipped with the computer) with an M.2 2230 solid-state drive, a mounting bracket for the M.2 2230 solid-state drive is required. Please contact Dell support to purchase the mounting bracket for the M.2 2230 solid-state drive.
The following image(s) indicate the location of the M.2 2280 solid-state drive and provides a visual representation of the removal procedure.
Steps
- Remove the screw (M2x3) that secures the M.2 2280 solid-state drive to the palm-rest and keyboard assembly.
- Slide and lift the M.2 2280 solid-state drive off the solid-state drive slot on the system board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\