Inspiron 16 5620 - for computers with DDR4 memory Service Manual

PDF

Removing the palm-rest and keyboard assembly

Prerequisites

  1. Follow the procedure in Before working inside your computer.
    NOTE:Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the memory module.
  4. Remove the M.2 2230 solid-state drive or M.2 2280 solid-state drive, whichever is applicable.
  5. Remove the wireless card.
  6. Remove the battery.
  7. Remove the display assembly.
  8. Remove the fan.
  9. Remove the coin-cell battery.
  10. Remove the I/O board.
  11. Remove the power button.
  12. Remove the power-button board.
  13. Remove the power-adapter port.
  14. Remove the system board.
  15. Remove the speakers.
  16. Remove the touchpad.

About this task

The following image(s) indicate the location of the palm-rest and keyboard assembly and provides a visual representation of the removal procedure.

Removing the palm-rest and keyboard assembly

Steps

After performing the pre-requisites, you are left with the palm-rest and keyboard assembly.
NOTE:The palm-rest and keyboard assembly includes the following components:
  • Palm rest
  • Keyboard
  • Wireless antenna (2)

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\