Inspiron 16 5620 - for computers with DDR4 memory Service Manual

PDF

Removing the power-adapter port

Prerequisites

  1. Follow the procedure in Before working inside your computer.
    NOTE:Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your computer.
  2. Remove the base cover.

About this task

The following image(s) indicate the location of the power-adapter port and provides a visual representation of the removal procedure.

Removing the power-adapter port

Steps

  1. Remove the three screws (M2.5x5) that secure the left display hinge to the system board.
  2. Open the left display hinge at an angle of 90 degrees.
  3. Peel the adhesive tape and disconnect the power-adapter port cable from the system board.
  4. Peel the adhesive tape that secures the power-adapter port cable to the system board.
  5. Lift the power-adapter port and the cable off the palm-rest and keyboard assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\