Inspiron 16 5630 Service Manual

PDF

Installing the I/O board

Prerequisites

CAUTION: The information in this section is intended for authorized service technicians only.
If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the io board and provides a visual representation of the installation procedure.

Installing the io board

Steps

  1. Align the screw holes on the I/O board with the screw holes on the system board and palm-rest and keyboard assembly.
  2. Align the ports on the I/O board with the slots on the palm-rest and keyboard assembly.
    Note
  3. Place the I/O board on the palm-rest and keyboard assembly.
  4. Replace the M2x3 screw to secure the I/O board to the palm-rest and keyboard assembly.
  5. Connect the I/O-board cable to the I/O board.
  6. Close the latch and replace the clear adhesive tape.
  7. Connect the fingerprint-reader cable to the I/O board and close the latch to secure the cable.
  8. Connect the coin-cell battery from the I/O board.
  9. Close the left display hinge and align the screw holes on the left display hinge with the screw holes on the palm-rest and keyboard assembly.
  10. Replace the two screws (M2.5x5) to secure the left display hinge to the palm-rest and keyboard assembly.

Next steps

  1. Install the battery.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\