Inspiron 16 5630 Service Manual

PDF

Installing the power button

Prerequisites

CAUTION: The information in this section is intended for authorized service technicians only.
If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the power button and provides a visual representation of the installation procedure.

Installing the power button

Steps

  1. Place the power button on the palm-rest and keyboard assembly.
  2. Place the power-button board on the power button.
  3. Align the screw holes on the power-button board with the screw holes on the palm-rest and keyboard assembly.
  4. Replace the two screws (M2x3) to secure the power-button board to the palm-rest and keyboard assembly.
  5. Connect the power-button board cable to I/O board and close the latch.
  6. Close the left display hinge and align the screw holes on the left display hinge with the screw holes on the palm-rest and keyboard assembly.
  7. Replace the two screws (M2.5x5) to secure the left display hinge to the palm-rest and keyboard assembly.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\