Inspiron 16 7620 2-in-1 Service Manual

Installing the 2230 solid-state drive

If you are replacing a component, remove the existing component before performing the installation process.

NOTE: This procedure applies if you are installing a M.2 2230 solid-state drive.

NOTE: Supported card configurations:

The following image(s) indicate the location of the 2230 solid-state drive and provides a visual representation of the installation procedure.

Installing the 2230 solid-state drive

Place and align the M.2 2230 solid-state drive on the mounting bracket.
Replace the screw (M2x2) that secures the M.2 2230 solid-state drive to the mounting bracket.
Flip over the M.2 2230 solid-state drive assembly.
Align the notch on the M.2 2230 solid-state drive with the tab on the M.2 card slot on the system board.
Slide the M.2 2230 solid-state drive into the M.2 card slot on the system board.
Replace the screw (M2x2) that secures the M.2 2230 solid-state drive mounting bracket to the system board.
Adhere the Mylar over the M.2 2230 solid-state drive and M.2 slot on the system board.