Inspiron 16 7620 2-in-1 Service Manual

PDF

Installing the 6-cell battery (87 Wh)

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

NOTE: This procedures only applies if you are installing a 6-cell battery (87 Wh) into your computer.

The following image(s) indicate the location of the 6-cell battery (87 Wh) and provides a visual representation of the installation procedure.

Installing the 6-cell battery (87 Wh)

Steps

  1. Using the alignment posts, place the 6-cell battery on the palm-rest and keyboard assembly.
  2. Align the screw holes on the 6-cell battery with the screw holes on the palm-rest and keyboard assembly.
  3. Replace the six screws (M2x3) that secure the 6-cell battery to the palm-rest and keyboard assembly.
  4. Connect the battery cable to the system board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\