Inspiron 16 7620 2-in-1 Service Manual

Installing the display assembly

If you are replacing a component, remove the existing component before performing the installation process.

The following image(s) indicate the location of the display assembly and provides a visual representation of the installation procedure.

Installing the display assembly

Place the display assembly on a clean and flat surface with the display panel facing up.
Gently place the palm-rest and keyboard assembly under the display hinges.
CAUTION: To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display assembly.
Connect the display cable to the connector on the system board and close the latch.
Adhere the tape that secures the display-cable connector latch to the system board.
Adhere the display-cable connector to the palm-rest and keyboard assembly.
Connect the display cable to the display board and close the latch.
Close the right-display hinge and align the screw holes on the right-display hinge with the screw holes on the system board.
Replace the three screws (M2.5x4) that secure the right-display hinge to the palm-rest and keyboard assembly.
Close the left-display hinge and align the screw holes on the left-display hinge with the screw holes on the I/O board.
Replace the two screws (M2.5x4) that secure the left-display hinge to the palm-rest and keyboard assembly.