Inspiron 16 7620 2-in-1 Service Manual

PDF

Installing the memory

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the memory and provides a visual representation of the installation procedure.

Installing the memory

Steps

  1. Lift the Mylar to access the memory-module slot.
  2. Align the notch on the memory module with the tab on the memory-module slot on the system board.
  3. Slide the memory module into the memory-module slot on the system board.
  4. Press down on the memory module till the securing clips click, locking the memory module in place.
    NOTE: Repeat steps 1 to 4 for each memory module being installed into your computer.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\