- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Inspiron 7620 2-in-1
- Disassembly and reassembly
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 16 7620 2-in-1 Service Manual
Removing the base cover
Prerequisites
- Follow the procedure in Before working inside your computer.NOTE: Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your computer.
About this task
NOTE: Before removing the base cover, ensure that there is no SD card installed in the SD card slot on your computer.
The following image(s) indicate the location of the base cover and provides a visual representation of the removal procedure.
Steps
- Remove the six screws (M2x4) that secure the base cover to the palm-rest and keyboard assembly.
- Loosen the three captive screws (M2x7.5) that secure the base cover to the palm-rest and keyboard assembly.
- Using your fingers pry the base cover from the gap at the bottom left and continue to work on the sides to open the base cover.
- Lift and slide the base cover off the palm-rest and keyboard assembly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\