Inspiron 24 5420 All-in-One Owner's Manual

PDF

Installing the media-card reader

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the media-card reader and provides a visual representation of the installation procedure.

Figure 1. Installing the media-card reader
Image: Installing the media-card reader

Steps

  1. Slide the media-card reader under the system board and align the screw hole on the media-card reader with the screw hole on the display-assembly base.
    NOTE:Ensure that the media-card reader cable stays above the system board.
  2. Connect the media-card reader cable to the system board and close the latch to secure the cable.
  3. Replace the screw (M3x3.5) that secures the media-card reader to the display-assembly base.

Next steps

  1. Install the system-board shield.
  2. Install the I/O cover.
  3. Install the stand.
  4. Install the back cover.
  5. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\