Inspiron 24 5420 All-in-One Owner's Manual

PDF

Installing the retractable-camera assembly

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the retractable-camera assembly and provides a visual representation of the installation procedure.

Figure 1. Installing the camera
Image: Installing the camera

Steps

  1. Slide and place the retractable-camera assembly on the display-assembly base.
  2. Replace the two screws (M3x5) that secure the retractable-camera assembly to the display-assembly base.
  3. Adhere the tape that secures the camera cable to the display-assembly base.
  4. Connect the camera cable to the system board.

Next steps

  1. Install the system-board shield.
  2. Install the I/O cover.
  3. Install the back cover.
  4. Install the stand.
  5. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\