Inspiron 24 5420 All-in-One Owner's Manual

PDF

Installing the stand

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

NOTE:The following procedure is applicable for both Y stand and Isosceles stand.
NOTE: For replacement of stand or stand hinges, the replacement kit is shipped with both stand and stand hinges. Both components are replaced together. Refer to the procedure for removing the stand and installing the stand.

About this task

The following image indicates the location of the stand and provides a visual representation of the installation procedure.
Figure 1. Installing the stand
Installing the stand

Insert the stands into the slots on the back cover until they snap into place on the display-assembly base.

Next steps

Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\