Inspiron 24 5420 All-in-One Owner's Manual

PDF

Installing the system-board shield

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the system-board shield and provides a visual representation of the installation procedure.
Figure 1. Installing the system-board shield
Image: Installing the system-board shield

Steps

  1. Align the screw holes on the system-board shield with the slots on the display-assembly base.
  2. Place system-board shield on the display-assembly base.
  3. Replace the four screws (M3x5) that secure the system-board shield to the display-assembly base.

Next steps

  1. Install the I/O cover.
  2. Install the back cover.
  3. Install the stand.
  4. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\