Inspiron 24 5420 All-in-One Owner's Manual

PDF

Installing the I/O cover

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the I/O cover and provides a visual representation of the installation procedure.
Figure 1. Installing bottom cover
Image: Installing the bottom cover

Steps

  1. Place the I/O cover on the display-assembly base.
  2. Align the screw holes on the I/O cover with the screw holes on the display-assembly base.
  3. Replace the two screws (M3x5) that secure the I/O cover to the display-assembly base and snap the I/O cover back into place.

Next steps

  1. Install the back cover.
  2. Install the stand.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\