Inspiron 24 5420 All-in-One Owner's Manual

PDF

Removing the media-card reader

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the stand.
  3. Remove the back cover.
  4. Remove the I/O cover.
  5. Remove the system-board shield.

About this task

The following image indicates the location of the media-card reader and provides a visual representation of the removal procedure.

Figure 1. Removing the media-card reader
Image: Removing the media-card reader

Steps

  1. Remove the screw (M3x3.5) that secures the media-card reader to the display-assembly base.
  2. Open the latch and disconnect the media-card reader cable from the system board.
  3. Gently slide and remove the media-card reader, along with its cable, from the media-card reader slot.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\