Inspiron 24 5420 All-in-One Owner's Manual

PDF

Removing the microphones

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the stand.
  3. Remove the back cover.
  4. Remove the I/O cover.
  5. Remove the hard drive.
  6. Remove the system-board shield.
  7. Remove the media-card reader.
  8. Remove the memory module.
  9. Remove the wireless card.
  10. Remove the M.2 2230 solid-state drive or, M.2 2280 solid-state drive, as applicable.
  11. Remove the integrated heat sink or, discrete heat sink.
  12. Remove the system board.

About this task

The following image indicates the location of the microphones and provides a visual representation of the removal procedure.

Figure 1. Removing the microphones
Image: Removing the microphones

Steps

  1. Remove the four screws (M2X3.5) that secure the microphone module to the display-assembly base.
  2. Peel the tape that secures the microphone cable to the display-assembly base.
  3. Remove the microphone cable from the routing guides on the display-assembly base.
  4. Lift the microphone module off the display-assembly base.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\