Inspiron 24 5420 All-in-One Owner's Manual

PDF

Removing the retractable-camera assembly

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the stand.
  3. Remove the back cover.
  4. Remove the I/O cover.
  5. Remove the system-board shield.

About this task

The following image indicates the location of the retractable-camera assembly and provides a visual representation of the removal procedure.

Figure 1. Removing the camera
Image: Removing the camera

Steps

  1. Disconnect the camera cable from the system board.
  2. Peel the tape that secures the camera cable to the display-assembly base.
  3. Remove the two screws (M3x5) that secure the retractable-camera assembly to the display-assembly base.
  4. Remove the retractable-camera assembly from the display-assembly base.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\