Inspiron 24 5420 All-in-One Owner's Manual

PDF

Removing the stand hinges

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the stand.
  3. Remove the back cover.
  4. Remove the I/O cover.
  5. Remove the system-board shield.
NOTE: For replacement of stand or stand hinges, the replacement kit is shipped with both stand and stand hinges. Both components are replaced together. Refer to the procedure for removing the stand and installing the stand.

About this task

The following image indicates the location of the stand hinges and provides a visual representation of the removal procedure.

Figure 1. Removing the stand hinges
Image: Removing the stand hinges

Steps

  1. Remove the 10 screws (M3x4.5) that secure the right and left stand hinges to the display-assembly base.
  2. Lift the stand hinges off the display-assembly base.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\