Inspiron 24 5420 All-in-One Owner's Manual

PDF

Removing the stand

Prerequisites

Follow the procedure in Before working inside your computer.
CAUTION:When servicing the computer, place it on an elevated, clean, and flat surface. Place the display flat on the surface with the stand over the edge of the surface. It is recommended to remove the stand to avoid accidental damage to the computer display when servicing.
Figure 1. Caution for stand
Image: Caution for stand
NOTE:The following procedure is applicable for both Y stand and Isosceles stand.
NOTE: For replacement of stand or stand hinges, the replacement kit is shipped with both stand and stand hinges. Both components are replaced together. Refer to the procedure for removing the stand and installing the stand.

About this task

The following image indicates the location of the stand and provides a visual representation of the removal procedure.
Figure 2. Removing the stand
Removing the stand

Steps

  1. Locate the tab on the stand, and push a scribe into the tab to release the stand from the display-assembly base.
  2. Lift the stand off the display-assembly base.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\