Inspiron 3668 Service Manual

PDF

Procedure

  1. Align and snap the optical-drive bezel to the optical drive.
  2. Align the screw holes on the optical-drive bracket with the screw holes on the optical drive.
  3. Replace the three screws (M2xL2) that secure the optical-drive bracket to the optical drive.
  4. Slide the optical-drive assembly into the optical-drive bay through the front of the computer.
  5. Align the screw hole on the optical-drive assembly with the screw hole on the chassis.
  6. Replace the screw (#6-32xL3.6) that secures the optical-drive assembly to the chassis.
  7. Lift and rotate the side-chassis away from the computer.
  8. Connect the data cable and power cable to the optical drive.
  9. Rotate the side-chassis towards the computer until it snaps into place.
  10. Place the computer in an upright position.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\