Integrated Dell Remote Access Controller 8 (iDRAC8) Version 2.00.00.00 RACADM Command Line Interface Reference Guide

PDF

cfgVFlashSD

This group is used to configure the properties for the Virtual Flash SD card.

  • NOTE: If the vFlash card is present but is not enabled, the query for any property under this group displays: 
ERROR: vFlash is not enabled.

To view the properties of this group, enable the vFlash using the command: 

racadm config -g cfgvFlashSD -o cfgvFlashSDEnable 1

The following sections provide information about the objects in the cfgVFlashSD group.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\