Integrated Dell Remote Access Controller 8 (iDRAC8) Version 2.00.00.00 RACADM Command Line Interface Reference Guide

PDF

racreset

Description

Resets iDRAC. The reset event is logged in the iDRAC log.

To run this subcommand, you must have the Configure iDRAC permission and configure user privilege.

  • NOTE: After you run the racreset subcommand, iDRAC may require up to two minutes to return to a usable state.
Synopsis 
racadm racreset soft
racadm racreset hard
racadm racreset soft -f
racadm recreset hard -f
Input
  • -f — This option is used to force the reset.

Output 
racadm racreset
                                                RAC reset operation initiated successfully. It may take up to a minute for the RAC to come online again.
Example
  • iDRAC reset. 
     racadm racreset

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\