Integrated Dell Remote Access Controller 8 (iDRAC8) Version 2.00.00.00 RACADM Command Line Interface Reference Guide

setniccfg

Description	Sets the iDRAC IP address for static and DHCP modes. To run this subcommand, you must have the Configure iDRAC privilege. . NOTE: The terms NIC and Ethernet management port may be used interchangeably.
Synopsis	racadm setniccfg -d racadm setniccfg -d6 racadm setniccfg -s <IPv4Address> <netmask> <IPv4 gateway> racadm setniccfg -s6 <IPv6 Address> <IPv6 Prefix Length> <IPv6 Gateway> racadm setniccfg -o
Input	`-d` — Enables DHCP for the NIC (default is DHCP disabled.) `-d6` — Enables AutoConfig for the NIC. It is enabled by default. `-s` — Enables static IP settings. The IPv4 address, netmask, and gateway must be specified. Otherwise, the existing static settings are used. `<IPv4Address>`, `<netmask>`, and `<gateway>` must be typed as dot-separated strings. racadm setniccfg -s 192.168.0.120 255.255.255.0 192.168.0.1 `-s6` — Enables static IPv6 settings. The IPv6 address, Prefix Length, and the IPv6 Gateway can be specified. `-o` — Enable or disable NIC.
Example	To Configure static IPv4 address for iDRAC NIC racadm setniccfg -s 192.168.0.120 255.255.255.0 192.168.0.1 Static IP configuration enabled and modified successfully Configure DHCP mode for iDRAC IPv4 racadm setniccfg -d DHCP is now ENABLED Configure DHCP mode for iDRAC IPv6 racadm setniccfg -d6 DHCP6 is now ENABLED