Use the
following safety guidelines to help protect your tablet from potential
damage and to help to ensure your personal safety. Unless otherwise
noted, each procedure included in this document assumes that the following
condition exists:
You have read the safety information that shipped with your tablet.
NOTE: : Before
working inside your tablet, read the safety information that shipped
with your tablet. For additional safety best practices information,
see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance
CAUTION: : Many repairs may only be done by a certified service
technician. You should only perform troubleshooting and simple repairs
as authorized in your product documentation, or as directed by the
online or telephone service and support team. Damage due to servicing
that is not authorized by Dell is not covered by your warranty. Read
and follow the safety instructions that came with the product.
CAUTION: : To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface,
such as a connector on the back of the tablet.
CAUTION: : Handle
components and cards with care. Do not touch the components or contacts
on a card. Hold a card by its edges or by its metal mounting bracket.
CAUTION: : When you disconnect a cable, pull on its connector or on its pull-tab,
not on the cable itself. Some cables have connectors with locking
tabs; if you are disconnecting this type of cable, press in on the
locking tabs before you disconnect the cable. As you pull connectors
apart, keep them evenly aligned to avoid bending any connector pins.
Also, before you connect a cable, ensure that both connectors are
correctly oriented and aligned.
NOTE: : The color
of your tablet and certain components may appear differently than
shown in this document.
To avoid damaging your tablet, perform
the following steps before you begin working inside the tablet.
Ensure that your work surface is flat and clean to prevent
the tablet cover from being scratched.
Turn off your tablet.
If the tablet is connected to a docking device (docked)
such as the optional docking station or keyboard dock, un-dock it.
Disconnect the power adapter from the tablet.
Press and hold the power button for a few seconds to remove
the flea power from the system board.
CAUTION: : To guard against electrical shock, always unplug your
tablet from the electrical outlet.
CAUTION: : Before
touching anything inside your tablet, ground yourself by touching
an unpainted metal surface, such as the metal at the back of the tablet.
While you work, periodically touch an unpainted metal surface to dissipate
static electricity, which could harm internal components.
Remove the storage SD card from the tablet.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\