Latitude 5290 2-in-1 Owner's Manual

PDF

Installing the display assembly

  1. Place the display panel on a plane surface.
  2. Connect the display cable to the connector on the system board
  3. Connect the battery cable to the connector on the system board.
  4. Install the display panel on the tablet and press the edges until they snap in.
  5. Flip the tablet and open the kickstand.
  6. Replace the M1.6 x 3 screws to secure the tablet to the display panel.
  7. Install the:
    1. uSIM/micro SD card
  8. Follow the procedure in After working inside your tablet.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\