Latitude 5290 2-in-1 Owner's Manual

PDF

Installing the front camera

  1. Insert the camera module into the slot on the tablet.
  2. Replace the M1.6 x 3 screws to secure the front camera module.
  3. Connect the front camera cable to the system board.

    NOTE: : Affix the adhesive tape that secures the front camera to the rear camera.

  4. Place the shielding cover to secure the front camera module.

    NOTE: : Handle the covering shield with care else it may break.

  5. Affix the conductive tape covering the camera module, heatsink, antenna and shielding cover.
  6. Install the:
    1. display panel
    2. battery
    3. uSIM/microSD card

      NOTE: : uSIM card is installed only on tablets shipping with WWAN module.

  7. Follow the procedure in After working inside your tablet.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\