Latitude 5290 2-in-1 Owner's Manual

PDF

Installing heat sink assembly

  1. Align the heat sink assembly with screw holders on the system board.
  2. Replace the M2 x 2.5 screws to secure the heat sink to the system board.

    NOTE: : Tighten the screws on the system board in the order of the callout numbers [1, 2, 3, 4] as indicated on the heat sink.

  3. Install the shielding covers on the heat sink assembly.

    NOTE: : Affix the black tape / copper tape that secure the IR camera cable for model shipped with IR camera (optional).

  4. Replace the shielding covers to cover the heat sink assembly.

    NOTE: : The shield covers can break if not handled carefully.

  5. Affix the conductive tapes to secure the shielding covers.
  6. Install the:
    1. display panel
    2. battery
    3. uSIM/microSD card

      NOTE: : uSIM card is installed only on tablets shipping with WWAN module.

  7. Follow the procedure in After working inside your tablet

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\