Latitude 5290 2-in-1 Owner's Manual

Installing system board

1. Align the system board with the screw holders on the tablet.
2. Tighten the M2 x 2.5 screws to secure the system board to the tablet.

   NOTE: : Remember to align the Type-C port and tighten the two screws to secure the port to the system chassis.

3. Route the antenna cables through the routing clips and channels.
4. Connect the docking board cable, speaker cable and the USH board cable to the connectors on the system board.
5. Install the:
   1. heat sink
   2. rear facing camera
   3. front facing camera
   4. system fan
   5. WLAN card
   6. SSD card
   7. battery
   8. display panel
   9. uSIM/microSD

      NOTE: : uSIM card is installed only on tablets shipping with WWAN module.

6. Follow the procedure in After working inside your tablet.