Latitude 5290 2-in-1 Owner's Manual

PDF

Removing the docking board

  1. Follow the procedure in Before working inside your tablet.
  2. Remove the:
    1. uSIM/microSD card

      NOTE: : uSIM card slot is available only on tablets shipping with WWAN module.

    2. display panel
    3. battery
  3. To release the docking board:
    1. Lift the latch and disconnect the docking board cable from the system board [1].

      NOTE: : The docking board FPC is obstructed by the speaker cable. Remove the right speaker first from the system to replace the docking board.

    2. Peel the docking board cable from adhesive on the tablet [2].
    3. Remove the M2 x 2 screws (2) securing the docking board bracket to the docking board [3].
    4. Lift the docking board metal bracket from the tablet [4].
      The image displays to remove the docking board
    5. Lift the docking board after releasing the cable from the adhesive.
    The image displays to lifting the docking board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\