Dell Latitude 7210 2-in-1 Service Manual

Installing the display panel assembly

1. Connect the display cable to the connector on the system board.
2. Replace the two M2x2.5 screws [3] securing the display cable bracket to the system board and replace the display cable bracket [2].
   
3. Slide the battery power switch on the system board to ON, carefully connect the display assembly to the system board using display cable, and flip the display assembly facing up.
   
4. Continue to work around the left side and the top side of the display assembly.
   
5. Flip over the computer, and then place the computer on a flat surface.
   
6. Open the kickstand.
   
7. Replace the six screws (non-security configuration) and tighten the six captive screws (security configuration) securing the display assembly of Latitude 7210 2-in-1 to the system chassis.
   
8. Close the kickstand.
   

   

9. Install the:
   1. SIM card tray
   2. microSD card
10. Follow the procedure in After working inside your tablet.