Latitude 5430 Chromebook Service Manual

PDF

Installing the 2230 solid-state drive

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

NOTE:Solid-state drives are fragile. Exercise care when handling the solid-state drive.

The following images indicate the location of the 2230 solid-state drive that is installed in M.2 slot and provides a visual representation of the installation procedure.

Installing the 2230 solid-state drive

Steps

  1. Align the notch on the M.2 2230 solid-state drive with the tab on the solid-state drive slot.
  2. Slide the M.2 2230 solid-state drive into the M.2 2230 solid-state drive slot on the system board.
  3. Replace the single screw (M2x2) that secure the solid-state drive to the system board.
  4. Replace the two screws (M2x2) that secure the solid-state drive thermal bracket to the solid-state drive.

Next steps

  1. Connect the battery cable to its connector on the system board.
  2. Install the SD card.
  3. Install the SIM card.
  4. Install the base cover.
  5. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\