Latitude 5430 Chromebook Service Manual
Installing the display assembly
Prerequisites
About this task
The following images indicate the location of the display assembly and provide a visual representation of the installation procedure.
Steps
- Place the display assembly on a clean and flat surface with the display panel facing up.
- Gently place the palm-rest and keyboard assembly under the display hinges.
CAUTION:To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display assembly.
- Close the left display hinge and align the screw holes on the left display hinge with the screw holes on the I/O board.
- Replace the three screws (M2.5x4) that secure the left display hinge to the palm-rest and keyboard assembly.
- Close the right display hinge and align the screw holes on the right display hinge with the screw holes on the system board.
- Replace the three screws (M2.5x4) that secure the right display hinge to the palm-rest and keyboard assembly.
- Connect the display cable to the connector on the system board and close the latch.
NOTE:For models shipped with touch screen display configuration, connect the touch display cable to the connector on the system board and close the latch.
- Align the screw holes on the display-cable bracket with screw holes on the system board.
- Replace the two screws (M2x3) to secure the display-cable bracket to the system board.
Next steps
- Connect the battery cable to its connector on the system board.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\