Latitude 5430 Chromebook Service Manual

PDF

Installing the power-button board

The power-button board is available in Latitude 5430 Chromebook 2-in-1 configurations only.

About this task

The following image indicates the location of the power-button board and provides a visual representation of the installation procedure.

Installing the power button

Steps

  1. Align and place the power-button board on to the computer chassis.
  2. Connect the power-button cable to the power-button board and close the latch.
  3. Replace the two screws (M1.6x1.5) that secure the power-button board to the palm-rest and keyboard assembly.
  4. Connect the power button cable to the connector on the system board.

Next steps

  1. Install the battery.
  2. Install the base cover.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\