Latitude 5430 Chromebook Service Manual

PDF

Installing the speakers

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following images indicate the location of the speakers and provide a visual representation of the installation procedure.

Installing the speakers

Steps

  1. Using the alignment posts, place the left and right speakers on the palm-rest and keyboard assembly.
  2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
  3. Adhere the tapes that secure the antenna cables to the system board.
  4. Connect the speaker cable to the connector on the system board and close the latch.
  5. Connect the touchpad cable to the connector on the system board and close the latch.
  6. Connect the keyboard cable to the connector on the system board and close the latch.
  7. Connect the keyboard-backlight cable to the connector on the system board and close the latch.
  8. Connect the fingerprint reader cable to the connector on the system board and close the latch.

Next steps

  1. Install the solid-state drive.
  2. Install the wireless card.
  3. Install the battery.
  4. Install the base cover.
  5. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\