Latitude 5430 Chromebook Service Manual

PDF

Installing the volume-control board

The volume-control board is available in Latitude 5430 Chromebook 2-in-1 configurations only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the volume-control board and provides a visual representation of the installation procedure.

Installing the volume control board

Steps

  1. Using the alignment posts, replace the volume control board into the slots on the palm-rest and keyboard assembly.
  2. Replace the two screws (M1.6x1.5) that secure the volume control board to the palm-rest and keyboard assembly.
  3. Connect the volume-control cable to the connector on the volume-control board and close the latch.
  4. Connect the volume control cable to the connector on the system board.

Next steps

  1. Install the battery.
  2. Install the base cover.
  3. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\