Dell Latitude 5501 Service Manual

Installing the hinge caps


If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the location of the hinge caps and provides a visual representation of the installation procedure.

Installing the hinge caps


  1. Place the hinge caps and slide outward on the display hinges.
  2. Replace the two (M2x2.5) screws to secure the hinge caps to the display hinge.

Next steps

  1. Install the display bezel.
  2. Install the display assembly.
  3. Install the WWAN card.
  4. Install the WLAN card.
  5. Install the battery.
  6. Install the base cover.
  7. Follow the procedure in After working inside your computer.

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\